Make your own free website on Tripod.com
Wiring Door Locks
Free Vehicle Wiring Diagrams
Technical Tips And Tricks
Below Retail Car Security Pricing
Unlimited ONLINE Installation Support
And A Whole Lot More!!

PROGRAMING THE MILLENIUM FX

Once you have installed the Millenium FX
using the diagram below, follow these simple procedures
BEFORE you power up the "brain" of the paging system.

(In order for the Millennium to learn the codes
you must shut off the handheld pager unit first)

1. CLOSE ALL DOORS, TRUNK, & HOOD.

2. PLUG IN THE POWER HARNESS FOR THE MILLENIUM FX.
(Please note you have to hold the hood
pin switch down instead of actually
closing the hood if you disconnect the battery)
Then ARM/activate the aftermarket alarm.

3. NEXT PUSH THE ARROW BUTTON
(the one with arrow pointing up and down),
holding the button down until you hear the beep,
relase the button, then press it 4 times more.
If you look at the display the clock will be set to "00:00"
now, wait for up to a minute and half as the unit learns the code.

4. AT THIS POINT, IF INSTALLED CORRECTLY, YOU WILL
GET THE "CONGRATUALTIONS" TUNE FROM THE MILLENIUM
PAGER, SIGNALING THAT YOU HAVE ACHIEVED THE PROGRAMING
OF THE SYSTEM. THE CLOCK WILL NOW RETURN TO THE CORRECT TIME
AND YOU CAN NOW DO YOUR FINAL SYSTEM TESTS.

Installation note:
"REQUIRED TO PROPERLY OPERATE THE PAGING SYSTEM."

YOU MUST DIODE ISOLATE THE ORANGE STARTER KILL OUTPUT
ON THE MILLENIUM WIRING HARNESS, WHEN ATTATCHING TO THE
STARTER KILL OF YOUR ALARM SYSTEM. THIS WILL ALLOW THE GROUND
OUTPUT TO DISENGAGE WHEN YOU DISARM YOUR CAR ALARM SYSTEM, AND
YOU WILL NOTICE THAT THE "ANTENNA" SYMBOL WILL DISAPEAR
ON THE PAGER. THIS IS NORMAL.

FINISH OFF THE INSTALLATION WITH BLACK TAPE, AND MOUNT
THE CONTROL BOX HIGH UP IN THE UNDERDASH AREA SECURELY.




The 12 Volt World
Of ALARMTEK!

VISIT OUR COLLECTION OF INFORMATIVE WEBSITES TODAY!